Question

Machinability of hard alloys and tool steels is improved by

a.

spherodising

b.

annealing

c.

tempering

d.

normalising

Answer: (b).annealing

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Machinability of hard alloys and tool steels is improved by

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Transformation range for ferrous material is the temperature interval during which __________ is formed during its heating.

Q. Powder metallurgy process does not make metal powder by

Q. In the blast furnace, incorporation of water vapour in the blast gives the following effect.

Q. Pick out the wrong statement.

Q. The usual energy consumption in electric arc furnace steel making is __________ KWh/ton of steel.

Q. Maximum permissible air velocity in pipelines is about __________ metre/second.

Q. Transition from laminar to turbulent zone in free convection heat transfer is governed by the critical value of

Q. The most economical channel section for the fluid flow is the one for which the discharge is maximum for a given cross-sectional area. Vertical velocity distribution in an open channel for laminar flow can be assumed to be

Q. Energy of the sun arises mainly from __________ reactions.

Q. Which of the following fastening devices has a head at one end and a nut fitted to the other ?

Q. Sudden fall of atmospheric pressure by a large amount is an indication of the

Q. Annealing ofwhite cast iron produces __________ iron.

Q. Resistance of an electrical conductor is proportional to its (where, l = length and A = cross-sectional area of the conductor)

Q. A solar cell converts the sunlight directly into __________ energy.

Q. If a nuclear reactor produces more fissile nuclear fuel than it consumes, then it is called a __________ reactor.

Q. Wrought iron is never shaped by

Q. Which one of the following is incombustible ?

Q. The softness or hardness of a grinding wheel depends upon the type & amount of bonding material used. For general purpose cutter grinding __________ grinding wheel is normally used.

Q. Tin based white metals are used, where bearings are subjected to

Q. Friction factor for fluid flow in pipe does not depend upon the

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!