Q. During decarburising of a plain carbon steel, the thickness of ferrite layer growth is proportional to

View solution

Q. With increase in annealing temperature, the following defect density decreases.

View solution

Q. Carnot cycle is also termed as the constant __________ cycle in thermodynamics.

View solution

Q. Thermistors are used in __________ devices.

View solution

Q. Broaching tools are usually made of

View solution

Q. The ratio of the shear stress to the principal stress on a principal plane is

View solution

Q. Case hardening is not done by

View solution

Q. Satellites burn off during re-entry to earth's atmosphere, because of the

View solution

Q. With increase in compression ratio, the volumetric efficiency of air compressor

View solution

Q. Neutrons are present in all atoms except that of

View solution

Q. Biological shield in a nuclear reactor is generally provided to protect against the

View solution

Q. Minimum safe distance between two liquid fuel storage tanks is equal to (where, H = height of the tank)

View solution

Q. Propulsion of rocket follows from the

View solution

Q. In multipass welds, shot peening is done after each pass to

View solution

Q. Pick out the correct statement.

View solution

Q. Consider the equilibrium A(g) + B(g) = AB(g). When the partial pressure of A is 10⁻² atm, the partial pressure of B is 10⁻³ atm and the partial pressure of AB is 1 atm, the equilibrium constant 'K' is

View solution

Q. Laser welding is widely employed in the __________ industries.

View solution

Q. Dryness factor of steam is defined as the ratio of the mass of vapor in the mixture to the mass of the mixture. Dryness factor of steam is measured by a __________ calorimeter.

View solution

Q. Which of the following is used to produce draught in the locomotive boilers ?

View solution

Q. Temper brittleness of a material can be fairly detected by the __________ test.

View solution