E-PolyLearning

Discussion Forum

Que. Nitrogenous fertiliser is required
a. during the early stage of growth to promote development of stem and leaves.
b. for accelerating fruit formation in later stage of growth.
c. to lessen the effect of excessive potash application.
d. none of these.
Correct Answer:during the early stage of growth to promote development of stem and leaves.
Confused About the Answer? Ask fellow aspirants for Details Here
Already Know Explanation? Add it Here to help others.

More Questions Like this:

Ammonium sulphate fertiliser is
Which of the following is not a measure component necessarily to be present in fertilisers?
Ammonia synthesis gas is produced from fuel oil by
Promoter used in NH₃ synthesis catalyst is
Two gas based fertiliser plants are located in
Steam reforming of naphtha produces ammonia synthesis gas. This is a/an __________ process.
__________ is not a fertiliser.
CaH₄(PO₄)₂ is the chemical formula of
Conversion of yellow phosphorous to red phosphorous is done by heating it in covered retorts at __________ °C in absence of air.
Triple superphosphate is made by reacting phosphate rock with __________ acid.
In the manufacture of orthophosphoric acid by strong H₂SO₄ leaching wet process, keeping the reactor temperature above 100°C, results in the formation of undesriable
Pick out the wrong statement.
Low grade phosphate rock can be used in electrical furnace, because
Conversion achieved in HNO₃ synthesis with the use of platinum catalyst is about 95-97%. The rate of formation of nitrogen dioxide from the oxidation of nitric acid is favoured by
Use of catalyst is a must in the ammonia manufacture, because the reaction is reversible as well as the heat of dissociation of N₂ & H₂ is high. The presence of promoter along with the catalyst helps in __________ of the catalyst.
With increases in pressure, the conversion of ammonium carbamate into urea
Which of the following gasifiers can be attached to coal based fertiliser plants ?
Fertiliser produced during soda ash manufacture by dual process is ammonium
Temperature and pressure in ammonia converter is
Steam reforming of naphtha is a source of hydrogen production for nitrogeneous fertiliser industry. What is the usual ratio of steam to carbon maintained in the process of steam reforming of naphtha ?

View All Questions on: Fertiliser Technology

Management and Accounting

Human Resource Management Marketing and Marketing Management Financial Management and Financial Markets Cost Accounting Business Statistics