Question

Fanning equation is given by below equation. It is applicable to __________ region flow.

a.

transition

b.

laminar

c.

turbulent

d.

both (b) and (c)

Answer: (d).both (b) and (c)

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Fanning equation is given by below equation. It is applicable to __________ region flow.

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The head loss due to sudden expansion is

Q. Pressure drop for turbulent fluid flow through a circular pipe is given by

Q. The Kozney-Carman equation, rewritten in terms of non-dimensional numbers gives (ΔP/pu² ) proportional to

Q. The equation given below is called the __________ .

Q. Pick out the Blake-Plummer equation (valid for large Nʀₑ) for fluid flow through beds of solids.

Q. The actual velocity at vena-contracta for flow through an orifice from a reservoir is given by

Q. For flow through a venturi at a particular discharge, the correct relationships among heads at points X, Y, and Z are

Q. The hydraulic radius for flow in a rectangular duct of cross-sectional dimension H, W is

Q. A pipe has a porous section of length L as shown in the figure. Velocity at the start of this section of V₀. If fluid leaks into the pipe through the porous section at a volumetric rate per unit area q(x/L)², what will be axial velocity in the pipe at any x ? Assume incompressible one dimensional flow i.e., no gradients in the radial direction.

Q. A free jet of water of cross-sectional area 0.01 m² and a velocity of 20 m/s strikes a plate and then flows in a plane parallel to the plate as shown in the figure below. The horizontal component of the force on the support is

Q. Pressure drop for laminar fluid flow through a circular pipe is given by

Q. Drag co-efficient for motion of spherical particles in a stationary fluid in the stoke's law range is

Q. Hydraulic mean radius for flow through packed bed of spherical particle of size, 'Dₚ', with porosity 'ε' is

Q. A conical tank with a bottom opening of cross-sectional area A is filled with water and is mounted on supports as shown in the figure. What is the force F with which plate X must be pushed up to prevent water from leaking ? Assume that the density of air is negligible as compared to the density of water ρL.

Q. The equivalent diameter for pressure drop calculation for a duct of square cross-section is given by(where, x = each side of the square duct)

Q. Each term of the Bernoulli's equation written in the following form, represents the total energy per unit

Q. For one dimensional flow of an incompressible fluid in unsteady state in x-direction, the continuity equation is given by

Q. The inherent characteristic of an equal percentage valve relating flow rate 'q' with valve stem movement 'x' are described by the equation

Q. Curve III in the below diagram represents a/an

Q. Colebrook equation for friction factor in turbulent flow is given by following equation. It reduces to Nikuradse equation for a value of ε/D equal to

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!