Question

In fluid flow, cavitation is caused, if the

a.

fluid velocity decreases to zero.

b.

total energy decreases.

c.

both (a) and (b).

d.

flow pressure approaches its vapor pressure at the prevailing temperature.

Answer: (d).flow pressure approaches its vapor pressure at the prevailing temperature.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In fluid flow, cavitation is caused, if the

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The ratio of the depth of flow to the hydraulic radius for the most economical trapezoidal section, in open channel flow is

Q. Which of the following denotes the effect of compressibility in fluid flow ?

Q. Nominal size of the discharge pipe of a pump is usually __________ the nominal size of the inlet pipe.

Q. The terminal velocity of a small sphere settling in a viscous fluid varies as the

Q. If the discharge of a centrifugal pump is throttled, then its suction lift

Q. Foot valves provided in pumps are __________ valves.

Q. With increasing flow rate, the hydraulic efficiency of a centrifugal pump

Q. The velocity profile for turbulent flow through a closed conduit is

Q. In case of hydraulically smooth pipe, the resistance to flow depends only on the Reynolds number, whereas for a hydraulically rough pipe, the resistance to flow is governed by the relative roughness. Two pipes are said to have the same hydraulic roughness, when they have equal values of

Q. Water hammer in a pipeline results from the

Q. Molten soap mass is transported by a __________ pump.

Q. At high Reynolds number

Q. Power loss in an orificemeter is __________ that in a venturimeter.

Q. The terminal velocity of a particle moving through a fluid varies as dₚⁿ. What is the value of 'n' for Newton's law regime ?

Q. What is the normal range of exit cone angle of a venturimeter ?

Q. The dimension of dynamic viscosity is

Q. Co-efficient of velocity is __________ the coefficient of discharge.

Q. All pipes of a particular nominal size have the same

Q. For the transfer of solution of thick slurry, the pump used is a __________ pump.

Q. Which of the following is not concerned with the fluid-particle interaction ?

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!