Question

The rate of heat transfer through a pipe wall is given by following equation. For cylinder of very thin wall, q can be approximated by

a.

A

b.

B

c.

C

d.

D

Answer: (d).D

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The rate of heat transfer through a pipe wall is given by following equation. For cylinder of very thin wall, q can be approximated by

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Graetz number is given by

Q. Harmonic mean temperature difference is given by

Q. Thermal diffusivity is given by

Q. At steady state the temperature variation in a plane wall, made of two different solids I & II is shown below. The thermal conductivity of material I

Q. In case of surface condensers, a straight line is obtained on plotting 1/U vs __________ on an ordinary graph paper.

Q. Fouling factor for a heat exchanger is given by (where, U₁ = heat transfer co-efficient of dirty surface U₂ = heat transfer co-efficient of clean surface)

Q. For a counter current heat exchanger with Tih = 80°C, T°c = 60°C, T°h = 50°C and Tic = 30°C, and the temperature difference between the two streams being the same everywhere along Z, the direction of flow of hot fluid. The temperature profile should satisfy

Q. Following number is called the __________ number.

Q. What is the logarithmic mean of r1 and r2 ?

Q. The following equation is the __________ analogy.

Q. The number given below is termed as the __________ number.

Q. Heat transfer co-efficient (h) for a fluid flowing inside a clean pipe is given by following equation. This is valid for the value of NRe equal to

Q. Prandtl number is given by

Q. For a liquid in laminar flow through a very long tube, when the exit fluid temperature approaches the wall temperature, the equation to be used is

Q. A graph between __________ is called Wilson plot.

Q. What is the geometric mean of two heat transfer areas A1 and A2 ?

Q. Hot water (0.01 m³ /min) enters the tube side of a counter current shell and tube heat exchanger at 80°C and leaves at 50°C. Cold oil (0.05 m³/min) of density 800 kg/m³ and specific heat of 2 kJ/kg.K enters at 20°C. The log mean temperature difference in °C is approximately

Q. In a heat exchanger, floating head is provided to

Q. Leidenfrost point is a term concerned with the

Q. A process stream of dilute aqueous solution flowing at the rate of10 Kg.s⁻¹ is to be heated. Steam condensate at 95°C is available for heating purpose, also at a rate of 10 Kg.s⁻¹. A 1 - 1 shell and tube heat exchanger is available. The best arrangement is

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!