Question

Increasing the liquor level in the evaporator results in the

a.

decreased capacity.

b.

increase in liquor film co-efficient.

c.

decreased effect of hydrostatic head.

d.

increased true temperature drop.

Answer: (a).decreased capacity.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Increasing the liquor level in the evaporator results in the

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Pick out the wrong statement.

Q. Convective heat transfer co-efficient in case of fluid flowing in tubes is not affected by the tube length/diameter ratio, if the flow is in the __________ zone.

Q. The actual temperature drop across the heating surface in an evaporator depends on the

Q. Which of the following is not used as a medium for high temperature heating ?

Q. Presence of a non-condensing gas in a condensing vapour

Q. The average heat transfer co-efficient for laminar film condensation on vertical surface is inversely proportional to (where, ΔT = Temperature drop across condensate film )

Q. Bulk of the convective heat transfer resistance from a hot tube surface to the fluid flowing in it, is

Q. Which of the following is concerned with both heat and mass transfer ?

Q. A backward feed multiple effect evaporator is better than forward feed for concentrating cold feed, because it provides

Q. A 10 cm diameter steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m².°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be

Q. Fouling factor

Q. In case of vertical tube evaporator, with increase in liquor level, the overall heat transfer co-efficient

Q. The steam ejector is used to

Q. For shell and tube heat exchanger, with increasing heat transfer area, the purchased cost per unit heat transfer area

Q. The thermal efficiency of a reversible heat engine operating between two given thermal reservoirs is 0.4. The device is used either as a refrigerator or as a heat pump between the same reservoirs. Then the coefficient of performance as a refrigerator (COP)R and the co-efficient of performance as a heat pump (COP)HP are

Q. Crystal size in a continuous crystalliser depends upon the

Q. Heat waves

Q. Air is best heated with steam in a heat exchanger of

Q. Which of the following is generally considered as opaque surface towards radiations?

Q. Black liquor generated during paper manufacture is concentrated in a

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!