Question

Film boiling occurs at __________ pressure.

a.

atmospheric

b.

sub-atmospheric

c.

negative

d.

very high

Answer: (d).very high

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Film boiling occurs at __________ pressure.

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Heat flux through several resistances in series in analogous to the current flowing through several

Q. Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the

Q. Vacuum is generally maintained in the vapour space of an evaporator mainly to

Q. Double pipe heat exchangers are used

Q. Steam traps are provided in steam carrying pipelines to

Q. A hot liquid is kept in a big room. The logorithm of the numerical value of the temperature difference between the liquid and the room is plotted against time. The plot will be very nearly a/an

Q. Radiation heat transfer rates does not depend upon the

Q. Which of the following is correct ?

Q. Convective heat transfer, in which heat is transferred by movement of warmed matter is described by

Q. As the difference between the wall temperature and bulk temperature increases, the boiling heat transfer co-efficient

Q. Heat transfer rate per unit area is called

Q. Log mean temperature difference (LMTD) cannot be used, if

Q. The critical radius 'r' of insulation on a pipe is given by

Q. As per Kirchoffs law, the ratio of the total radiating power to the absorptivity of a body depends on the

Q. If the baffle spacing in a shell and tube heat exchanger increases, then the Reynolds number of the shell side fluid

Q. The heat transfer by radiation from a mild steel surface is to be reduced by reducing the emissivity of the surface. This can be best achieved by

Q. __________ paint has the maximum absorption coefficient.

Q. Which of the following is unimportant in forced convection ?

Q. Steam is to be condensed in a shell and tube heat exchanger, 5 m long with a shell diameter of 1 m. Cooling water is to be used for removing the heat. Heat transfer co-efficient for the cooling water, whether on shell side or tube side is the same. The best arrangement is

Q. In a multiple effect evaporator, the effect of boiling point elevation is to

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!