Question

In a backward feed multiple effect evaporator

a.

feed is introduced in the first effect.

b.

feed flows from low pressure to high pressure.

c.

no pumps are required between successive effects.

d.

none of these.

Answer: (b).feed flows from low pressure to high pressure.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a backward feed multiple effect evaporator

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. The Grashoff number is defined as the ratio of the

Q. According to Reynolds analogy, Stanton number is equal to (where, f = Fanning friction factor)

Q. The absorptivity of a body is equal to its emissivity

Q. Absorptivity and refletivity of a perfect black body are respectively

Q. In thermal radiation for a black body (where, ε is emissivity and α is absorptivity)

Q. Viscous & heat sensitive liquids are concentrated in __________ evaporators.

Q. 1 BTU/hr.ft.°F is equal to __________ kcal/hr. m.°C.

Q. Heat transfer by radiation between two bodies at T1 & T2 and in an ambient temperature of Ta°C depends on

Q. The ratio of momentum diffusivity to thermal diffusivity is the __________ number.

Q. For a perfectly transparent surface (like gases), the

Q. Water is normally used as a coolant in the heat exchange equipments mainly because of its

Q. The rate of emission of radiation by a body does not depend upon the

Q. Which of the following has maximum thermal conductivity at the same temperature?

Q. Maximum heat transfer rate is obtained in __________ flow.

Q. In case of __________ boiling, the liquid temperature is below the saturation temperature and the boiling takes place in the vicinity of the heated surface.

Q. The ratio of velocity head to tube side return loss in case of a multipass shell and tube heat exchanger is

Q. Terminal point temperature differences between fluids in case of a heat exchanger is termed as

Q. LMTD can't be used as such without a correction factor for the

Q. Fqra cold viscous feed, backward feed gives __________ than forward feed.

Q. Walls of a cubical oven are of thickness l, and they are made of material of thermal conductivity k. The temperature inside the oven is 100°C and the inside heat transfer co-efficient is 3k/l. If the wall temperature on the outside is held at 25°C, what is the inside wall temperature in degree centigrade ?

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!