Q. The advantage of using a 1 - 2 shell and tube heat exchanger over a 1 - 1 shell and tube heat exchanger is

View solution

Q. For a multipass shell and tube heat exchanger, the LMTD correction factor is always

View solution

Q. If heat transfer rate varies with the time, it is termed as

View solution

Q. Pick out the wrong statement.

View solution

Q. Tube expansion allowances exist in __________ heat exchanger.

View solution

Q. Pick out the wrong statement.

View solution

Q. Agitated film evaporator is suitable for concentrating __________ liquids.

View solution

Q. The thickness of condensate layer in filmwise condensation depends on the

View solution

Q. If the thermal conductivity of a wall material is independent of temperature, the steady state temperature distribution in the very large thin plane wall having steady, uniform surface tempeature follows __________ law.

View solution

Q. Choose the correct equation.

View solution

Q. In a forward feed multiple effect evaporator unit

View solution

Q. In case of heat flow by conduction for a cylindrical body with an internal heat source, the nature of temperature distribution is

View solution

Q. For heat flow through very thick walled cylinder, use____mean radius.

View solution

Q. Indirect contact heat exchangers are preferred over direct contact heat exchangers, because

View solution

Q. In SI units, fouling factor is expressed in

View solution

Q. An ejector is used to

View solution

Q. Extremely large or small volumes of fluids are generally best routed through the shell side of a shell and tube heat exchanger, because of the

View solution

Q. All analogy equations connecting friction factor and heat transfer co-efficient apply only to

View solution

Q. Electro-magnetic spectrum range, which is important for radiation varies from __________ microns.

View solution

Q. Overall heat transfer co-efficient of a particular tube is U1. If the same tube with some dirt deposited on either side has coefficient U2, then

View solution