Question

In a shell and tube heat exchanger, floating head is used for

a.

large temperature differentials.

b.

high heat transfer co-efficient.

c.

low pressure drop.

d.

less corrosion of tubes.

Answer: (a).large temperature differentials.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a shell and tube heat exchanger, floating head is used for

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Steam trap is used to

Q. Kirchoff's law is applicable to

Q. In a forward feed multiple effect evaporator, the pressure is

Q. In a co-current double pipe heat exchanger used for condensing saturated steam over the inner tube, if the entrance and exit conditions of the coolant are interchanged, then the rate of condensation will

Q. Which of the following situations can be approximated to a steady state heat transfer system ?

Q. Sensible heat absorbed by 1 lb of water when it is heated from 32 to 212°F may be around __________ BTU.

Q. In a heat exchanger, the rate of heat transfer from the hot fluid to the cold fluid

Q. With increase in temperature, the total emissivity of conductors

Q. Loss of heat from untagged steam pipe to the ambient air is by

Q. Fruit juice (a heat sensitive material) can be concentrated in a __________ evaporator.

Q. Tubes are held between top and bottom tube sheets in Calenderia type evaporator by keeping

Q. Nusselt number is the ratio of the temperature gradient at the wall to

Q. The Stefan-Boltzman constant depends on the

Q. The units of resistance to heat transfer is

Q. Thermal conductivity of a gas at low density, __________ with increase in temperature.

Q. Nusselt number is a function of Prandtl number and __________ number of fluid in natural convection heat transfer.

Q. __________ heat exchanger is used for chilling oil to be dewaxed.

Q. It is not recommended to use a 1-2 shell and tube heat exchanger for a particular heat duty, whenever the LMTD correction factor is

Q. Pick out the wrong statement.

Q. In sub-cooled boiling,

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!