Q. In sub-cooled boiling,

View solution

Q. With increase in temperature, the thermal conductivity of a gas

View solution

Q. Which of the following parameters of the fluid is not very important, while deciding its route in a shell and tube heat exchanger?

View solution

Q. Corrosiveness of steam condensate is due to the presence of

View solution

Q. The driving potential for the crystal growth during crystallisation is the __________ of the solution.

View solution

Q. jH factor for heat transfer depends upon the __________ number.

View solution

Q. Critical value of the __________ number governs the transition from laminar to turbulent flow in free convection heat transfer.

View solution

Q. The thermal boundary layer at NPr > 1

View solution

Q. In the free convection regime of pool boiling, the heat flux is proportional to

View solution

Q. With increase in temperature, the thermal conductivity of fresh lubricating oil

View solution

Q. Fresh orange juice contains 12% (by weight) solids and the rest water 90% of the fresh juice is sent to an evaporator to remove water and subsequently mixed with the remaining 10% of fresh juice. The resultant product contains 40% solids. The kg of water removed from 1 kg fresh juice is

View solution

Q. Kg of liquid evaporated per hour in an evaporator is defined as its

View solution

Q. Pick out the correct statement.

View solution

Q. Open pan evaporators are preferred to be used, when the solution to be concentrated is

View solution

Q. The maximum heat transfer co-efficient from steam heating will be attained when the steam is

View solution

Q. Mode of heat transfer involved in the cooling of air cooled internal combustion engine is

View solution

Q. Steady state one dimensional heat flow by conduction as given by Fourier's low does not assume that

View solution

Q. The left face of a one dimensional slab of thickness 0.2 m is maintained at 80°C and the right face is exposed to air at 30°C. The thermal conductivity of the slab is 1.2 W/m.K and the heat transfer co-efficient from the right face is 10 W/m².K. At steady state, the temperature of the right face in °C is

View solution

Q. In a shell and tube heat exchanger, the shell side fluid velocity can not be changed by changing the

View solution

Q. To reduce the tube side pressure drop for the same flow rate, the heat exchanger recomended is

View solution