Question

With increase in pressure, the relative volatility for a binary system

a.

increases.

b.

decreases.

c.

remains same.

d.

either (a) or (b), depends on the system.

Answer: (b).decreases.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. With increase in pressure, the relative volatility for a binary system

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Low viscosity absorbent is preferred for reasons of

Q. Mass transfer co-efficient (K) and diffusivity (D) are related according to film theory as

Q. Drying operation under vacuum is carried out to

Q. Air initially at 101. 3 kPa and 40°C and with a relative humidity of 50%, is cooled at constant pressure to 30°C. The cooled air has a

Q. Separation of two or more components of a liquid solution can not be achieved by

Q. Stefan's law describes the mass transfer by

Q. At minimum reflux ratio for a given separation

Q. The mass diffusivity, the thermal diffusivity and the eddy momentum diffusivity are same for, NPr = NSc = __________

Q. Dew point of a gas-vapour mixture

Q. In a packed absorption tower, if the equilibrium and operating lines are both straight lines, then the ratio, HETP/HTUOG __________ the absorption factor.

Q. Which of the following plays an important role in problems of simultaneous heat and mass transfer ?

Q. In case of an absorber, the operating

Q. Total reflux in a distillation operation requires minimum

Q. The amount of steam required per unit quantity of distillate in case of steam distillation will be reduced by

Q. The difference of wet bulb temperature and adiabatic saturation temperature of unsaturated mixture of any system is

Q. Fenske's equation for determining the minimum number of theoretical stages in distillation column holds good, when the

Q. When the temperature and humidity of air is low, we usually use __________ draft cooling tower.

Q. Make up water is required in a cooling tower to replace the water lost by

Q. Which of the following quantities need not be fixed before starting the design of a co-current absorber ?

Q. Mass transfer co-efficient of liquid is

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!