Question

Boiling point diagram is

a.

not affected by pressure.

b.

affected by pressure.

c.

a plot of temperature vs. liquid composition.

d.

a plot of temperature vs. vapour composition.

Answer: (b).affected by pressure.

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Boiling point diagram is

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. When acetone is added in a two layer mixture of methyl isobutyl ketone and water at 30°C, the acetone distributes between the two layers and the composition of the layer follows two solubility curves. For this system,

Q. Steam distillation is used to

Q. Freundlich equation applies to the adsorption of solute from

Q. For ethanol-water system, the lowering of distillate quality from 95% to 92% will cause __________ plate requirement.

Q. A packed tower compared to a plate tower for a particular mass transfer operation

Q. Which of the following is the most commonly used leaching solvent in vegetable oil industry ?

Q. In an absorber, HETP does not vary with the

Q. Large quantity of silica gel is normally dried in a __________ dryer.

Q. For the same system, if the same liquid used in an absorber is decreased, the tower height will

Q. Which of the following same diameter columns gives lowest pressure drop per unit height ?

Q. Diffusion in concentrated solutins differs from that in dilute solutions, because of the change in the __________ with the concentration of the solution.

Q. Stage efficiency in a leaching process depends on the

Q. Operating velocity in a packed tower is usually __________ the flooding velocity.

Q. The Knudsen diffusivity is dependent on the

Q. Solvent extraction is the terminology applied to the liquid-liquid extraction, which is preferred for the separation of the components of liquids, when

Q. Inside the distillation column, the

Q. Diffusivity in concentrated solutions differs from that in dilute solutions, because of the changes in

Q. Occurrence of 'case hardening' during drying of a high moisture solid cake __________ the drying rate.

Q. Which of the following is not a continuous drier ?

Q. Which of the following equipments is not used for gas dispersion ?

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!