Question

At constant pressure, with increase of temperature, the dew point will

a.

increase

b.

decrease

c.

remain unchanged

d.

increase/decrease ; depends on the temperature

Answer: (a).increase

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. At constant pressure, with increase of temperature, the dew point will

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. For a single component absorber, the operating line is straight only when plotted in term of __________ units.

Q. Raschig ring made of procelain cannot be used for treating concentrated

Q. H₂S present in naphtha reformed gas is removed by absorbing with

Q. During constant rate drying period, vaporisation rate per unit drying surface area

Q. Pick out the wrong statement.

Q. In rectifying section of a continuous distillation column, the

Q. For a distillation column operating at minimum reflux, the

Q. A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))

Q. Flash distillation is suitable for the separation of components

Q. In Mcabe-Thiele method, at infinite reflux ratio

Q. Leaching rate is independent of the

Q. Molality is defined as the number of gm moles of solute per __________ of solvent.

Q. __________ is concerned with the adsorption equilibria.

Q. Fractional solvent extraction

Q. In the layout plan for a vacuum distillation unit, operating at 60 mm Hg, supported by a barometric condenser, the appropriate place for the location of vacuum drum for collecting the distillate will be

Q. At 750°K and 1 atm, the approximate value of Schmidt number for air is

Q. Calculation of mass transfer co-efficient is mostly/normally done using __________ theory.

Q. Which of the following is used for the concentration of rubber latex ?

Q. Unsaturated air (with dry and wet bulb temperatures being 35 and 25°C respectively) is passed through water spray chamber maintained at 35°C. The air will be

Q. For absorbing a sparingly soluble gas in a liquid, the

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!