Question

Overall distillation column efficiency for most of the refinery columns can be given by (for μ = 0.07 - 1.4 cp and relative volatility < 4) (where η = overall column efficiency, % μ = molal average viscosity of feed at average column temperature and pressure, cp Δp = pressure drop per tray, psi)

a.

A

b.

B

c.

C

d.

D

Answer: (a).A

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Overall distillation column efficiency for most of the refinery columns can be given by (for μ = 0.07 - 1.4 cp and relative volatility < 4) (where η = overall column efficiency, %...

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. For laminar flow (Nʀₑ < 2100) in steel pipe, the optimum inside pipe diameter is given by

Q. For annular flow of a fluid, the ratio of the equivalent diameter for pressure drop calculation to the equivalent diameter for heat transfer calculation is

Q. Pressure drop due to pipe fittings can be estimated by the following equation, where, Lₑ = equivalent length of straight pipeline which will incur the same frictional loss as the fitting and D = diameter of the fitting. The value of Lₑ/D (dimensionless) for 45° elbow and 180° close return bends would be respectively around

Q. In a rotary drier, the average retention time of solid is (where Z = length of the drier, metres ρ = apparent solid density, kg/m³ L = flow rate of dry solids, kg/see. m² drier cross-section H = hold up of solid.)

Q. In a double pipe concentric heat exchanger, the equivalent diameter of annulus for heat transfer would be (where, D₁ and D₂ are I.D. of inner and outer pipes)

Q. For turbulent flow (Nʀe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft³/sec.ρ = fluid density, lb/ft³ μ = fluid viscosity, centipoise Dᵢ = optimum inside pipe diameter, inches)

Q. The following ratio, is normally taken as

Q. Stress-strain diagram for low carbon steel/mild steel is shown below in the Figure. The point 'A' on the Figure represents the

Q. Equivalent diameter for heat transfer calculation for a duct of square cross-section having each side as 'd' will be

Q. Friction factor for turbulent flow in a new pipe is given by

Q. In a shell and tube heat exchanger having triangular pitch, the shell side equivalent diameter is given by

Q. Pick out the wrong statement.

Q. In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)

Q. Souders Brown equation given by the following equation, is used for the calculation of the __________ in a continuous distillation column.

Q. Lₑ/D for fully open globe value may be around

Q. Lug support is

Q. Pick out the wrong statement pertaining to the use of valve tray, seive tray and bubble cap trays in continuous distillation column.

Q. With increase in the number of shell passes, the value of Fᴛ

Q. Holes of a sieve tray are arranged in triangular pitch of __________ times the hole diameter.

Q. __________ tray arrangement is recommended for distillation column having diameter upto 4 ft.

Recommended Subjects

Are you eager to expand your knowledge beyond Basic Chemical Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!