Q. If L is true length of chain and L’ is incorrect length of the chain the correction to area A is _________

(Where ∆L/L = e, e is small and A’ is measured area)

View solution

Q. If L is true length of chain and L’ is incorrect length of the chain the correction to Volume V is _______

(Where ∆L/L = e, e is small and V’ is measured area)

View solution

Q. The difference between a measurement and the true value of the quantity measured is _____

View solution

Q. The difference between the two measured values of the same quantity is ______

View solution

Q. Which of the following are not sources of errors?

View solution

Q. A tape may be too long or an angle measuring instrument may be out of adjustment. Then such type of error comes under which source of error?

View solution

Q. Investigation of observations of various types shows that accidental errors follow a definite law. This law is called ______

View solution

Q. A line which joins subsidiary stations on the main line is called _____

View solution

Q. In which type of surveying only linear measurements are made?

View solution

Q. A survey station is prominent on the chain line and can be either at the beginning of the chain or at the end. Such stations are known as ______

View solution

Q. What is laid by joining the apex of the triangle to any point on the opposite side or by joining two points on any two sides of a triangle?

View solution

Q. The accuracy in the location of the objects depends upon the accuracy in laying the ________

View solution

Q. Survey stations must be mutually visible to obtain a good system of line.

View solution

Q. In case, to get a well-proportioned or well-shaped triangle, no angle should be less than _________

View solution

Q. Each triangle or portion of a skeleton must be provided with sufficient tie lines to obtain good system of lines.

View solution

Q. As far as possible, the main survey line should not pass through _____

View solution

Q. Check lines should form well-conditioned triangles to obtain a good system of survey lines.

View solution

Q. The simplest instrument used for setting right angles is a _____

View solution

Q. Which of the following is not a common form of cross staff?

View solution

Q. Which cross staff consists of two cylinders of equal diameter placed one on top of the other?

View solution