Q. A single contour line can split into two in case of a change in elevations.

View solution

Q. A contour line must close upon itself.

View solution

Q. Contour lines cross a watershed or ridge line at _____

View solution

Q. What is the shape of contour lines in case of a valley?

View solution

Q. What is the shape of contour lines in case of a watershed?

View solution

Q. The same contour appears on either sides of a ridge or valley, for the highest horizontal plane that interests the ridge must cut it on both sides.

View solution

Q. What is the process of spacing the contours proportional between the plotted ground points established by indirect methods?

View solution

Q. The methods of interpolation are based on the assumption that the slope of ground between the two points is uniform.

View solution

Q. Which of the following is not a chief method of Interpolation?

View solution

Q. Which of the following methods is extremely rough and is used for small scale work only?

View solution

Q. The positions of contour points between the guide points are located by _______

View solution

Q. Which of the following Interpolation method is accurate and time consuming?

View solution

Q. In which of the following methods Interpolation is done with the help of a tracing paper?

View solution

Q. In cross sections method, cross sections are run traverse to the centre line of a road, railway or canal etc.

View solution

Q. In the case of hilly terrain, the tacheometric method may be used with advantages.

View solution

Q. In cross sections method, If there are irregularities in the surface between two cross lines, additional guide points may be located on intermediate cross lines.

View solution

Q. _______ is a line lying throughout on the surface of the ground and preserving a constant inclination to the horizontal.

View solution

Q. Which of the following cannot be used to locate the contour gradient in the field?

View solution

Q. If a level is used to locate the contour gradient, it is not necessary to set the level on the contour gradient.

View solution

Q. If the inclination of contour gradient is given, its direction from a point may be easily located either on the map or on the ground.

View solution