Q. For adjusting the angular error, the error may be distributed equally among all the angles.

View solution

Q. Closing error can be given as________

View solution

Q. Which of the following corresponds to the correction applied to the bearing of the last side?

View solution

Q. If traversing is done by taking bearings of the lines, the closing error in bearing may be determined by _______________

View solution

Q. Which of the following is a method of adjusting a closed traverse?

View solution

Q. Relative error of closure is given as____________

View solution

Q. Closing error can be briefly explained in which of the following set of methods?

View solution

Q. For a traverse containing 10 sides, what would be the correction applied for the first side, if it consists a closing error of +1.92?

View solution

Q. What would be the correction for any side of a traverse in axis method if it has a closing error e = 0.93, length of side and axis would be 243.13 and 100 respectively?

View solution

Q. Which of the following indicates the correct value of precise closing error if e = 0.54 and lengths of sides are 92.69 m, 119.23 m, 92.64 m, 42.96 m and 60.96 m.

View solution

Q. Departure refers to __________

View solution

Q. When measured towards southward, latitude is negative.

View solution

Q. Departure can be given as __________

View solution

Q. Consecutive co-ordinates are also known as __________

View solution

Q. Latitude and Departure equations will never return positive values.

View solution

Q. For calculating latitude and departure they must be converted into__________

View solution

Q. By which of the following step, Independent co-ordinate can be obtained?

View solution

Q. Total co-ordinate point is referred as___________

View solution

Q. If the value of θ = 72º 49ꞌ, find the value of departure for side having a length 300 m.

View solution

Q. The value of θ = 162º 49ꞌ in Reduced Bearing system can be represented as ____________

View solution