Q. The formula for length of the curve can be given as ____________

View solution

Q. Sharpness of the curve can be determined by _________

View solution

Q. Relation between radius and degree of curvature can be approximately given as __________

View solution

Q. The relation of radius and degree of curvature cannot be applied for small radius.

View solution

Q. The maximum curvature provided for a highway is about__________

View solution

Q. While designing a curve, which among the following must be taken into consideration?

View solution

Q. Length of the curve depends on the criteria used for defining the degree of the curve.

View solution

Q. Mid-ordinate is also known as __________

View solution

Q. The formula for tangent length can be given as __________

View solution

Q. Find the value of mid-ordinate if the value of R can be given as 22.19m and the angle is given as 19˚21ꞌ.

View solution

Q. What would be the length of the curve, if the radius of the curve is 24.69m and the angle is given as 12˚42ꞌ?

View solution

Q. Find the tangent length if the radius of the curve and its angle were given as 42.64m and 42˚12ꞌ.

View solution

Q. What would be the value of apex distance if the angle is given as 13˚42ꞌ and the radius of the curve is given as 19.24m?

View solution

Q. If the radius of the curve is given as 14.96m and the angle is about 32˚24ꞌ, find the length of the chord.

View solution

Q. Which among the following indicates the correct set of methods for setting out a simple curve?

View solution

Q. In linear method of setting out curve, which of the following is not used?

View solution

Q. Which of the following methods is used when curve to be designed is short?

View solution

Q. In angular method of setting a curve, which of the following is used?

View solution

Q. For setting the tangent, which process is most commonly used?

View solution

Q. P.T, P.I, P.C are the basic requirements for setting a curve.

View solution