Q. In the below figure, f1/f2 = _______

View solution

Q. Difference between upper and lower stadia reading gives __________

View solution

Q. In stadia method, diaphragm in tachometer is provided with there stadia hairs and stadia hair reading is taken by looking through a diaphragm.

View solution

Q. Stadia method is based on the principle that ratio of perpendicular to the base is constant.

View solution

Q. If d = 2.94 km, what would be the combined correction for curvature and refraction?

View solution

Q. Find the value of R.L, if B.M = 400 m, B.S = 1.142 m, F.S = 2.121 by using rise and fall method?

View solution

Q. Find the correction for curvature and correction for refraction, if the value of d = 2400 m?

View solution

Q. The combined correction for curvature and refraction can be given as _______

View solution

Q. If the R.L of a B.M is 100m and back sight is 1.225m, find the H.I at the station?

View solution

Q. If the staff at the station point is not held vertically, the R.L at the observation would be ______________

View solution

Q. Which of the following represents a form of Bench Mark (B.M)?

View solution

Q. Rise and fall method provides check in calculations for all sights.

View solution

Q. Which of the following indicates the formula for arithmetic check?

View solution

Q. The formula for calculating R.L can be given as _________

View solution

Q. While doing construction work, which among the following is more suitable?

View solution

Q. Height of the Instrument method is a less tedious and simple process.

View solution

Q. Which type of levelling is done on the phenomenon, the difference in elevation between two points is proportional to the difference in atmospheric pressure at these points?

View solution

Q. What is the error in mm for precise levelling for benchmarks of widely distributed points?

View solution

Q. What is the error in mm for accurate levelling for principal benchmarks or for extensive surveys?

View solution

Q. What is the error in mm for ordinary levelling for location and construction surveys?

View solution