Q. Voltage follower is also known as ___________

View solution

Q. Which configuration of op-amp is used for filter circuit?

View solution

Q. Amplification of low level signal can be done using___________

View solution

Q. For an ideal op-amp, zero input results in zero output.

View solution

Q. Phase difference between two voltages at frequencies above 10Hz can be measured using _________

View solution

Q. What is the operating range of X-Y plotter?

View solution

Q. What is the expression for phase angle using X-Y plotter? (Assume t₀ be time interval between zero crossing of signals and T be time period of signals).

View solution

Q. What is the use of flip-flop in electronic phase meters?

View solution

Q. Phase-Sensitive detectors are used for measuring phase of ______________

View solution

Q. Rejection capability of Phase sensitive detector is depended on the averaging time of smoothing filter.

View solution

Q. For what purpose, FET’s are included in phase sensitive detectors?

View solution

Q. Which of the following relation is correct for phase angle and reactive power?

View solution

Q. Which of the following is the expression of power factor?

View solution

Q. What is the relation for phase angle (in degree) of a signal with time delay Δt and frequency f?

View solution

Q. Which of the following cannot be used as a unit for frequency?

View solution

Q. Which of the following represents the correct relationship between frequency and angular frequency?

View solution

Q. What will be the frequency of a system in which 35 events occur in 7 seconds?

View solution

Q. Which of the following device can be used for measurement of frequency?

View solution

Q. All waves in electromagnetic spectrum has the same speed in vacuum.

View solution

Q. Which of the following frequency range represents an audible frequency range of humans?

View solution