Q. Wagner device is a ____________

View solution

Q. Which is the guarding arm?

View solution

Q. Bridge is suitable for _________

View solution

Q. In Maxwell’s capacitance bridge for calculating unknown inductance, the various values at balance are, R₁ = 300 Ω, R₂ = 700 Ω, R₃ = 1500 Ω, C₄ = 0.8 μF. Calculate R₁, L₁ and Q factor, if the frequency is 1100 Hz.

View solution

Q. In Wein’s bridge, the output frequency is determined by __________

View solution

Q. What is the disadvantage of Maxwell Bridge?

View solution

Q. Hay’s Bridge is used for measuring __________

View solution

Q. Maxwell’s Inductance Capacitance Bridge is used for measuring ___________

View solution

Q. The four arms of an AC bridge network are as follows:

Arm AB: unknown impedance
Arm BC: standard capacitor C₂ of 1000pf
Arm CD: a non-inductive resistance of R of 100 Ω in parallel to a capacitor of 0.01 μF
Arm DA: a non-inductive resistance of 1000 Ω

The supply frequency is 50 Hz and connected across terminals B and D. If the bridge is balanced with the above value, determine the value of unknown Impedance.

View solution

Q. The four arms of an AC bridge network are as follows:

Arm AB: unknown impedance
Arm BC: standard capacitor C2 of 1000pf
Arm CD: a non-inductive resistance of R of 100 Ω in parallel to a capacitor of 0.01 μF
Arm DA: a non-inductive resistance of 1000 Ω

The supply frequency is 50 Hz and connected across terminals B and D. If the bridge is balanced with the above value, determine the value of unknown Capacitance.

View solution

Q. In the Owen’s bridge shown in below figure, Z₁ = 200∠60°, Z₂ = 400∠-90°, Z₃ = 300∠0°, Z₄ = 400∠30°. Then the _______

View solution

Q. The Bridge shown in the below figure is ______________

View solution

Q. In Maxwell’s Bridge, as shown in the figure below, the values of the resistance R₁ and inductance L₁ of a coil are to be calculated after the bridge is balanced. The values are?

View solution