Q. A 50 Hz, bar primary CT has a secondary with 500 turns. The secondary supplies 5 A current into a purely resistive burden of 1 Ω. The magnetizing ampere-turns are 200. What is the ratio error at full load, if the iron loss is 1.5 W and magnetizing mmf is 100 A?

View solution

Q. A 1000/5 A, 50 Hz correct transformer has a secondary burden comprising a non-inductance of 1.6Ω. The flux in the core at full load is?

View solution

Q. A 1000/5 A, 50 Hz correct transformer has a secondary burden comprising a non-inductance of 2Ω. What is the ratio error, if the iron loss is 3 W and magnetizing mmf is 250 A?

View solution

Q. A 200/1 Current Transformer (CT) is wound with 400 turns on the secondary on a toroidal core. When it carries a current of 180 A on the primary, the ratio is found to be -0.5%. If the number of secondary turns is reduced by 1, the new ratio error (in %) will be?

View solution

Q. A (350 A/ 7A), 50 Hz current transformer has a primary bar. The secondary burden is a pure resistance of 1 Ω and it draws a current of 5 A. The magnetic core requires 350 AT for magnetization. Find the percentage ratio error.

View solution

Q. The observation when the secondary winding of a current transformer is open-circuited is?

View solution

Q. Usually a CT has ____________

View solution

Q. A PT is a device which is ___________

View solution

Q. The CT supplies current to the current coil of a wattmeter power factor meter, energy meter and, an ammeter. These are connected as?

View solution

Q. In a moving iron meter, the deflection torque is proportional to?

View solution

Q. The full-scale deflection current of an ammeter is 4 mA and its internal resistance is 400Ω. If this meter is to have a full deflection of 10 A, what is the value of the shunt resistance to be used?

View solution

Q. The full-scale deflection current of a meter is 4 mA and its internal resistance is 400Ω. This meter is to have full deflection when 400 V is measured. What is the value of the series resistor to be used?

View solution

Q. Two ammeters, one with a full-scale current of 1 mA and internal resistance of 100 Ω and other a full-scale current of 10 mA and internal resistance of 25 Ω are in parallel. What is the total current, these two meters can carry without the reading out of scale in any meter?

View solution

Q. A meter has a full scale of 90° at a current of 1 A. This meter has a perfect square law response. What is the current when the deflection angle is 45°?

View solution

Q. The scale of a dynamometer type instrument marked in terms of RMS value would be__________

View solution

Q. Moving Iron Instrument can be used as ____________

View solution

Q. A 10 mA PMMC ammeter reads 4 mA in a circuit. Its bottom control spring snaps suddenly. The meter will now show __________

View solution

Q. The standardization of AC potentiometer is done by ____________

View solution

Q. The inductance of a certain moving- iron ammeter is expressed as L = 10 + 3θ – \(\frac{θ^2}{4}\) μH, where θ is the deflection in radian from the zero position. The control spring torque is 25 × 10⁻⁶ Nm/rad. The meter carries a current of 5 A. What is the deflection?

View solution

Q. A current of – 8 + 6\(\sqrt{2}\) (sin (ωt + 30°)) A is passed through three meters. The respective readings (in ampere) will be?

View solution