Q. Energy meter can be directly used in measurement.

View solution

Q. Creeping in an energy meter can be found using _________

View solution

Q. Preliminary light load adjustment involves _________

View solution

Q. Creep adjustment involves _________

View solution

Q. Light load adjustment involves _________

View solution

Q. Low power factor adjustment involves _________

View solution

Q. Full load u.p.f adjustment involves _________

View solution

Q. Phase sequence indicator gives the maximum value of phase voltages.

View solution

Q. Synchronization of A.C. supply means __________

View solution

Q. How many types of phase sequence indicators are there?

View solution

Q. A rotating phase sequence indicator consists of ________

View solution

Q. The three coils are ________

View solution

Q. Excitation of the three coils produces ________

View solution

Q. Eddy e.m.f produces a torque.

View solution

Q. Disc rotation is determined by ________

View solution

Q. In the Two wattmeter method of measuring power in a balanced three-phase circuit, one wattmeter shows zero and the other positive maximum. The load power factor is?

View solution

Q. Two watt meters, which are connected to measure the total power on a three-phase system supplying a balanced load, read 10.5 kW and – 2.5 kW respectively. What is the total power?

View solution

Q. Power flowing in 3-phase, 3-wire system is measured by two wattmeter whose readings are 7000 W and -2500 W. If the voltage of the circuit is 400 V, then what will be the value of capacitance introduced in each phase to make one wattmeter reads zero? The frequency is 50 Hz.

View solution

Q. A single-phase load is connected between R and Y terminals of a 220 V, symmetrical, 3-phase, 4 wire systems with phase sequence RYB. A watt-meter is connected in the system. The watt-meter will read (pf = 0.8 lagging)?

View solution

Q. The two-wattmeter method is used to measure active power. The system is a 3-phase, 3- wire system. Then, the power reading is?

View solution