Q. For what value of flow behaviour index, does the consistency index has a dimension independent of time?

View solution

Q. What will be the dimension of the flow consistency index for a fluid with a flow behaviour index of 3?

View solution

Q. What will be the dimension of the flow consistency index for a fluid with a flow behaviour index of -1?

View solution

Q. Which of the following contribute to the reason behind the origin of surface tension?

View solution

Q. What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.05 N/cm² greater than the outside pressure? (Take surface tension as 0.075 N/m)

View solution

Q. A soap bubble of d mm diameter is observed inside a bucket of water. If the pressure inside the bubble is 0.075 N/cm², what will be the value of d? (Take surface tension as 0.075 N/m)

View solution

Q. A liquid jet of 5 cm diameter has a pressure difference of N/m². (Take surface tension as 0.075 N/m)

View solution

Q. The rise in the level of a liquid in a tube is h. What will be the rise in the level if the same amount of liquid is poured into a tube of half the diameter.

View solution

Q. The ratio of the surface tension S and density ρ of liquid 1 and 2 are 1:2 and 1:4 respectively. Equal amount of the two liquids is poured into two identical tubes. What will be the ratio of the rise in the liquid level in the two tubes? (Assume the angle of contact to be same)

View solution

Q. The rise in the level of a liquid in a tube is h. If half the amount is poured outside, what will be the new rise in liquid level?

View solution

Q. If a glass tube of 10 mm diameter is immersed in water, what will be the rise or fall in capillary?

(Take surface tension = 0.075 N/m, g = 10 m/s² and angle of contact = 0)

View solution

Q. A water drop of diameter 1 cm breaks into 1000 similar droplets of same diameter. What will be the gain or loss in the surface energy? (Take surface tension as 0.075 N/m)

View solution

Q. If there is no exchange of heat between system and surrounding where system comprises of a compressible fluid but the heat is generated due to friction, the process is an adiabatic.

View solution

Q. For a compressible fluid, if there is no change in specific volume at constant temperature, what type of process it is?

View solution

Q. If the fluid is incompressible, do thermodynamic properties play an important role in its behaviour at varying temperature and pressure?

View solution

Q. If for same temperature and pressure change, the value of bulk modulus is compared for isothermal process and adiabatic process, which one would be higher?

View solution

Q. The value of gas constant is same for all the gases.

View solution

Q. Calculate the pressure exerted by 9 kg of air at a temperature of 20℃ if the volume is 0.8m³. Assuming ideal gas laws are applicable.

View solution

Q. A gas weighs 16 N/m³ at 30℃ and at an absolute pressure of 0.35 N/mm². Determine the gas constant.

View solution

Q. A cylinder of 0.8 m³ in volume contains superheated steam at 70℃ and 0.4 N/m² absolute pressure. The superheated steam is compressed to 0.3 . Find pressure and temperature.

View solution