Question

Which type of component in the hydraulic system supports less vibration and noise?

a.

Flow control valve

b.

Oil reservoir

c.

Rotatory pumps

d.

Pressure gauge

Posted under Mechatronics

Answer: (c).Rotatory pumps

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Which type of component in the hydraulic system supports less vibration and noise?

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Duplex cylinders contain more than one piston.

Q. Which type of cylinder has rod length less than the piston diameter?

Q. Which is not an example of linear actuator?

Q. Which type of cylinders can extend piston from both sides?

Q. Linear actuators can only be made using hydraulic push system.

Q. Comb drives can be referred as linear actuators.

Q. Spring return type single acting cylinder is commonly used for tool and object holding purpose.

Q. Which type of cylinder contains series of nested tubing?

Q. What does PSI stand for in terms of pressure measurement?

Q. Which type of cylinder should be used to generate high pressure in narrow radial space?

Q. Which vice is also known as post vice?

Q. Which is an example of linear actuator?

Q. Tie-Rod cylinder can bear more pressure than welded cylinder.

Q. Which vice is also known as tail vice?

Q. Which type of hydraulic cylinders use 4 or more bolts to tie up the head from the base plate?

Q. What is the percentage change in amount of water flowing through a valve in one hour when originally the rate of flow from the valve was 15 m³/hr which was reduced to 5 m³/hr?

Q. What is the rate of flow of water from a cylindrical valve if the cylindrical valve has a diameter of 10 cm and velocity of water is 5 m/s?

Q. What is the rate of flow of water in Litres per second from a cylindrical valve if the cylindrical valve has a diameter of 10 cm and velocity of water is 12 m/s?

Q. What is the percentage change in amount of water flowing through a valve in one hour when originally the rate of flow from the valve was 10 m³/hr which was reduced to 5 m³/hr?

Q. In “two way ball valves” the flow can be switched and controlled by rotating the ball in 90 degrees.

Recommended Subjects

Are you eager to expand your knowledge beyond Mechatronics? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!