Q. Where are no equalizer rings connected?

View solution

Q. Inequality in brush arm currents caused due to different emf induced in different parallel paths may give rise to copper losses. These effects can be avoided by using _________

View solution

Q. Which of the following method will completely neutralize the armature reaction in a DC machine?

View solution

Q. What is the exact location of compensating winding?

View solution

Q. Exact purpose of compensating winding in a DC generator is _________

View solution

Q. Function of interpole flux is_________

View solution

Q. Why dummy coils are connected in DC machine?

View solution

Q. The most likely cause(s) of sparking at the brushes in a DC machine is /are ____________

View solution

Q. Each of the following statements regarding interpoles is true except______________________

View solution

Q. Axis undergo shifting as a result of armature reaction, can be balanced by ______

View solution

Q. The choice of average coil voltage determines the minimum number of commutator segments for its design.

View solution

Q. Compensating winding will provide incomplete neutralization ____________

View solution

Q. Cross-magnetizing effect of armature reaction can be reduced by __________

View solution

Q. To counter the effect of shift in MNA due to armature reaction, which of the following component can be shifted?

View solution

Q. Calculate the number of conductors on each pole piece required in a compensating winding for a 6-pole lap-wound dc armature containing 286 conductors. The compensating winding carries full armature current. Assume ratio of pole arc/ pole pitch = 0.7.

View solution

Q. A compensating winding with ampere-turns greater than peak ampere turns is required in order to neutralize the effect of armature reaction because _____________

View solution

Q. If pole arc is less than pole pitch, a compensating winding will have ampere-turns _________ (compare to peak ampere turns).

View solution

Q. What is the pole arc/pitch ratio, if 360 AT compensating winding is used where 1960 AT is peak value?

View solution

Q. Only drawback of compensating winding is _______

View solution

Q. Resultant ampere-turn distribution of a DC machine is given by _________

View solution