Q. Where will speed-torque characteristics will lie when armature reaction is considered?

View solution

Q. Working range of the speed-torque characteristic, with increasing speed will ___________

View solution

Q. For speed x rpm, we get field current If₁ and for speed y rpm, we get the field current If₂. If y is greater than x then, ________________

View solution

Q. 400-V dc shunt motor takes a current of 5.6 A on no-load and 68.3 A on full-load. Armature reaction weakens the field by 3%. What is the ratio of full-load speed to no-load speed? Given: Ra = 0.18 Ω, brush voltage drop= 2 V, Rf = 200 Ω.

View solution

Q. In which of the following method, effect of armature reaction is more?

View solution

Q. Which of the following DC motor has the poorest speed control?

View solution

Q. In variable speed motor ____________

View solution

Q. The speed of a motor falls from 1200 rpm at no-load to 1050 rpm at rated load. The speed regulation of the motor is ____________

View solution

Q. Which of the following is not the method of speed control in DC series motor?

View solution

Q. For speed reversal, field control method is suitable.

View solution

Q. For large motors what is the ratio of compensating winding is required for increasing the speed of the motor?

View solution

Q. In diverter resistor field control method of DC series motor, variable resistor is added ________

View solution

Q. Why it is advisable to use inductively wound diverter resistor?

View solution

Q. For higher diverter resistance, speed-torque characteristic will lie ____________

View solution

Q. In tapped field control method ____________

View solution

Q. Which of the following method will not give many speed values for a DC series motor?

View solution

Q. In series-parallel speed control method ______________

View solution

Q. Where diverters are used?

View solution

Q. What will happen to the speed of a series motor if the temperature of armature resistance is increased?

View solution

Q. For which speed control method we get minimum efficiency?

View solution