Q. The ___________ incorporates a line receiver in order to convert the optical signal into the electrical regime.

View solution

Q. A regenerative repeater is called as ____________

View solution

Q. The wavelength range of __________ will be fruitful for the operating wavelength of the system referring to the system performance.

View solution

Q. How many encoding schemes are used in optical fiber communication system design requirements?

View solution

Q. In ________ the optical channel bandwidth is divided into non-overlapping frequency bands.

View solution

Q. A multiplexing technique which does not involve the application of several message signals onto a single fiber is called as _________

View solution

Q. Which of the following is not an optical fiber component?

View solution

Q. ________technique involves an increase in the number of components required.

View solution

Q. Time division multiplexing is inverse to that of frequency division multiplexing.

View solution

Q. Sampling rate for each speech channel on 32-channel PCM is 8 KHz each encoded into 8 bits. Determine number of bits in a frame.

View solution

Q. Sampling rate for each speech channel on 32-channel PCM is 8 KHz each encoded into 8 bits. Determine the transmission rate for system with 256 bits in a frame.

View solution

Q. Sampling rate for each speech channel on 32-channel PCM is 8 KHz each encoded into 8 bits. Determine the bit duration with transmission rate of 2.048 Mbits/s.

View solution

Q. The bit duration is 488 ns. Sampling rate for each channel on 32-channel PCM is 8 KHz encoded into 8 bits. Determine the time slot duration.

View solution

Q. Sampling rate for each speech channel on 32-channel PCM is 8 KHz each encoded into 8 bits. Determine duration of frame with time slot duration of 3.9 μs.

View solution

Q. Sampling rate for each speech channel on 32-channel PCM is 8 KHz each encoded into 8 bits. Determine the duration of multi-frame if duration of a frame is 125 μs.

View solution

Q. Determine excess avalanche noise factor F(M) if APD has multiplication factor of 100, carrier ionization rate of 0.02.

View solution

Q. Compute average number of photons incident at receiver in APD if quantum efficiency is 80%, F (M) = 4, SNR = 144.

View solution

Q. Determine incident optical power if zₘ=864, wavelength = 1 μm.

View solution

Q. Determine wavelength of incident optical power if zₘ=864, incident optical power is -60.7 dB, Bᴛ=1 * 10⁷.

View solution

Q. Determine total channel loss if connector loss at source and detector is 3.5 and 2.5 dB and attenuation of 5 dB/km.

View solution