Q. The system designer finds greatest interest in the ______________

View solution

Q. How many parameters are usually worked upon by the measurement techniques in attenuation?

View solution

Q. What type of light source is usually present in the cut-back method?

View solution

Q. The device used to remove any scattered optical power from the core is __________

View solution

Q. What is the hierarchy of the process at the receiving end of the cut-back technique?

View solution

Q. What is the unit of measurement of the optical attenuation per unit length?

View solution

Q. Determine the attenuation per kilometer for a fiber whose length is 2 km, output voltage is 2.1 V at a wavelength of 0.85 μm. The output voltage increases to 10.7 V when the fiber is cut-back to leave 2 metres. Determine the attenuation per km for the fiber at wavelength 0.85 μm.

View solution

Q. ___________ are used to allow measurements at a selection of different wavelengths.

View solution

Q. Cut-back technique is destructive.

View solution

Q. Which technology is used by the backscatter measurement method?

View solution

Q. ________________ measurements checks the impurity level in the manufacturing process.

View solution

Q. _____________ may be achieved by replacing the optical fibers with thin resistance wires.

View solution

Q. A scattering cell consists of ______ square solar cells called as Tynes cell.

View solution

Q. ___________ removes the light propagating in the cladding.

View solution

Q. ___________ measurements give an indication of the distortion to the optical signals as they propagate down optical fibers.

View solution

Q. The measurement of dispersion allows the _________ of the fiber to be determined.

View solution

Q. How many types of mechanisms are present which produce dispersion in optical fibers?

View solution

Q. Intermodal dispersion is nonexistent in ________ fibers.

View solution

Q. In the single mode fibers, the dominant dispersion mechanism is ____________

View solution

Q. Devices such as ___________ are used to simulate the steady-state mode distribution.

View solution