Q. Which of the following is the main drawback of the slab technique?

View solution

Q. ________________ method is used to measure the nonlinear refractive index of the silica fiber.

View solution

Q. Near field scanning method provides a rapid method for acquiring the refractive index profile.

View solution

Q. A multimode fiber has many cutoff wavelengths.

View solution

Q. What does ‘a’ stands for in the given equation?

Mg=(πa/λ)²(n₁² – n₂²)

View solution

Q. The _________ wavelength is defined as the wavelength greater than which the ratio of the total power and the fundamental mode power has to be decreased to less than 0.1 dB.

View solution

Q. How many methods are used to determine the effective cutoff wavelength?

View solution

Q. What is the name of the test used to determine the efficient values of the effective cutoff wavelength?

View solution

Q. The effective cutoff wavelength for a cabled single mode fiber will be generally smaller than that of the un-cabled fiber.

View solution

Q. How many bend effects are produced in the fiber?

View solution

Q. _______________ method does not require a leaky mode correction factor or equal mode excitation.

View solution

Q. The _______ method is the most commonly used method for the determination of the fiber refractive index profile.

View solution

Q. The ____________ affects the light gathering capacity and the normalized frequency of the fiber.

View solution

Q. The numerical aperture for a step index fiber is sine angle of the ____________

View solution

Q. The calculations of the numerical aperture from a refractive index data are less accurate for the graded index fibers than for step index fibers.

View solution

Q. Far field pattern measurements with regard to multimode fibers are dependent on the _____________ of the fiber.

View solution

Q. The screen is positioned 10 cm from the fiber end face. When illuminated from a wide angled visible source the measured output pattern size is 6.2 cm. Calculate the approximate numerical aperture of the fiber.

View solution

Q. During the fiber drawing process, the fiber outer diameter is maintained constant to within ________

View solution

Q. What is the minimum value of accuracy in diameter is needed to avoid radiation losses in the fiber?

View solution

Q. Which of the following is a non-contacting optical method of on-line diameter measurement?

View solution