Q. A large-area photodiode is utilized in the receiver to eliminate any effects from differing fiber and faces.

View solution

Q. _____________ may be used for measurement of the absolute optical attenuation on a fiber link.

View solution

Q. The handheld optical power meter has a measurement accuracy of ________

View solution

Q. Which sensors are used for alteration of spectral range in equipment?

View solution

Q. Which of the following cannot be used in equipment for field measurements?

View solution

Q. Complicated and involved fiber connection arrangements should be _________ in case of field measurements.

View solution

Q. Which of the following are not considered as environmental conditions required for field measurements?

View solution

Q. In case of field measurements, the equipment must have ___________ power consumption keeping in mind the battery operation.

View solution

Q. Which of the following is not included in the optical fiber link measurement test?

View solution

Q. ____________ affects both the fiber attenuation and dispersion.

View solution

Q. The techniques used to determine the refractive index profile can also be used to determine the core diameter.

View solution

Q. The shadow velocity is given by 0.4 μm μs⁻¹ and shadow pulse of width 300 μs is registered at an instant by the photodetector. Determine the outer diameter of the optical fiber in μm.

View solution

Q. The shadow method is used for measurement of the outer diameter of an optical fiber. The apparatus employs a rotating mirror with an angular velocity of 4 rad/s which is located at 10 cm from the photo detector. Compute the shadow velocity.

View solution

Q. Which of the following is a non-contacting optical method of on-line diameter measurement?

View solution

Q. What is the minimum value of accuracy in diameter is needed to avoid radiation losses in the fiber?

View solution

Q. During the fiber drawing process, the fiber outer diameter is maintained constant to within ________

View solution

Q. The screen is positioned 10 cm from the fiber end face. When illuminated from a wide angled visible source the measured output pattern size is 6.2 cm. Calculate the approximate numerical aperture of the fiber.

View solution

Q. Far field pattern measurements with regard to multimode fibers are dependent on the _____________ of the fiber.

View solution

Q. The calculations of the numerical aperture from a refractive index data are less accurate for the graded index fibers than for step index fibers.

View solution

Q. The numerical aperture for a step index fiber is sine angle of the ____________

View solution