Q. Which of the following are the two main characteristics of receivers?

View solution

Q. What circuit provides the initial selectivity in a receiver?

View solution

Q. The ability to pick up week signals by a receiver is called _________

View solution

Q. What is the input signal level that is approximately equal to the average internally generated noise value called?

View solution

Q. Analog signals : Signal to noise ratio:: Digital signals _________

View solution

Q. A sensitive and selective receiver can be made using only amplifiers, selective filters, and a demodulator.

View solution

Q. What type of receivers converts all incoming frequency into a lower frequency for better selectivity and sensitivity?

View solution

Q. What is the output of a mixer circuit?

View solution

Q. What is connected between the antenna and the mixer to avoid oscillator radiation?

View solution

Q. Which of the following is not an advantage of using RF amplifiers in the initial stage of signal selection?

View solution

Q. The LNA of a transducer has failed during the transmission of a signal. Which component’s failure has caused this?

View solution

Q. What type of oscillators are used to input a wide range of frequencies to the IF amplifier?

View solution

Q. Multiplexing increases the number of communication channels for transmission.

View solution

Q. In which of the following systems multiplexing is not necessary?

View solution

Q. Time division multiplexing: Digital signal:: Frequency division multiplexing:?

View solution

Q. What type of multiplexing is widely used in cellphones?

View solution

Q. The transmission of multiple signals in a common frequency without interference is called _______

View solution

Q. For frequency division multiplexing who defines the channel bandwidth?

View solution

Q. What is the individual carrier frequency of each signal called?

View solution

Q. Which circuit does the actual multiplexing process in frequency division multiplexing?

View solution