Question

What is it called when the noise is present in the transmission line but gets canceled at the receiver?

a.

Cancellation mode

b.

Common mode cancellation

c.

Common mode rejection

d.

Rectification

Posted under Avionics Engineering

Answer: (c).Common mode rejection

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. What is it called when the noise is present in the transmission line but gets canceled at the receiver?

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Coaxial cables are ________ lines?

Q. What is the device that converts the balanced line to an unbalanced line called?

Q. A current carrying conductor is only called a transmission line if the length of the line is _____ long at the signal frequency?

Q. Cables that carry RF signal are not ______

Q. For an operating frequency of 450 MHz, what length of a pair of conductors is considered to be a transmission line?

Q. Calculate the physical length of the transmission line for an operating frequency of 450 MHz and 3⁄8 λ long.

Q. Which of the following is not a type of coaxial cable connector?

Q. Which of the following is called as UHF connector?

Q. Which of the following is widely used for connecting coaxial cables test instruments?

Q. Which type of coaxial cable connector is the least expensive?

Q. Which is the best type of coaxial cable connector in terms of performance?

Q. Two parallel lines appear as a complex impedance when the transmission line is equal to the wavelength of the signal.

Q. Parallel conductors form a distributed inductance with the insulation.

Q. What the model of transmission line that appears as a distributed low-pass filter consisting of series inductors and resistors and shunt capacitors and resistors called?

Q. What is the surge impedance if a capacitance of 0.0022 μF (2200 pF) is measured for 100 ft and the inductance of each conductor is measured separately and then added, for a total of 5.5 μH?

Q. The characteristic impedance of a cable of length 1m is 50 Ω. What is the characteristic impedance of the same cable of length 100 m?

Q. Speed of signal in transmission line is equal to the speed of light.

Q. The velocity factor of a coaxial cable is typically 0.8. What is the speed of transmission?

Q. What is the velocity factor of a coaxial cable having an insulator with dielectric constant 2.1?

Q. Calculate the velocity factor if the transmission speed is 2.04 x 10⁸.

Recommended Subjects

Are you eager to expand your knowledge beyond Avionics Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!