Q. Which technique uses spot beam antennas to divide the area covered by the satellite into smaller segments?

View solution

Q. Spatial-division multiple access (SDMA) depends on satellite location and not frequency.

View solution

Q. Which of the following is not a satellite subsystem?

View solution

Q. Which of the following is not a part of the propulsion subsystem of a satellite?

View solution

Q. Which of the following are common baseband signals transmitted from the earth ground station?

View solution

Q. Which of the following components receives, translates the signal frequency and re-transmits the signal in a satellite?

View solution

Q. Why is there a huge spectrum space between the transmitted and received signal in satellite communication?

View solution

Q. Which of the following transponders convert the uplink signal to downlink signal using two mixers

View solution

Q. In a regenerative transponder, the signal is demodulated and modulated again before transmission.

View solution

Q. What is the number of transponders if the satellite uses 12 channels of frequency and frequency reuse is implemented?

View solution

Q. Why is it not possible to provide transmit function by wideband amplifier and mixer circuits?

View solution

Q. Which of the following is not true?

View solution

Q. Telemetry, command, and control (TC and C) subsystem allow a ground station to monitor and control conditions in the satellite.

View solution

Q. What is the use of the band pass filter in the receiver section?

View solution

Q. The satellite in the earth station must be steerable even for a geosynchronous satellite.

View solution

Q. In Rf tuning, what is the first local oscillator?

View solution

Q. If the earth station downlink signal received is at fₛ = 4.08 GHz, what first stage local-oscillator frequency fₗₒ is needed to achieve IF of 770 MHz?

View solution

Q. Which of the following amplifiers is used in the transmitter substation?

View solution

Q. Which part of the transmitter subsystem modulates the baseband signal?

View solution

Q. In digital systems, analog signals are first digitized with PCM converters before modulation.

View solution