Q. What is the Tup test also known as?

View solution

Q. What is the height from which the weight is dropped in falling weight test?

View solution

Q. The tensile strength of the rail should not be less than ______

View solution

Q. Where are third quality rails used?

View solution

Q. Third quality rails are painted by which colour on the end face?

View solution

Q. 90 UTS rails are more resistant against wear and tear as compared to Manganese rails with 72 UTS.

View solution

Q. What is the advantage of End hardened rails?

View solution

Q. What is done for hardening of Head hardened rails?

View solution

Q. Where does maximum lateral wear of rail occurs?

View solution

Q. Which of the following is responsible for wear and tear of rails in coastal areas?

View solution

Q. The difference in height of the rail at end and at a point 30cm away from the end is called as ________

View solution

Q. Where are rail lubricators used?

View solution

Q. Which of the following methods cannot be used for measurement of wear of rails?

View solution

Q. Interchanging inner and outer rails will lead to ______

View solution

Q. What can be done to prevent Hogging of rails?

View solution

Q. In which type of defect patches of metal fall from the rail table?

View solution

Q. What causes wheel burns?

View solution

Q. Which of the following locations are less likely to develop wheel burns?

View solution

Q. Which of the following defects occur because of heavy bearing pressure on small area of contact?

View solution

Q. When vehicles pass over corrugated rails, a roaring sound is produced.

View solution