Q. The value of C is taken as ____ for bitumen pavements.

View solution

Q. What is the minimum velocity required in drainage to maintain flow?

View solution

Q. The area of the drainage is expressed in __________

View solution

Q. For a bitumen pavement calculate the discharge in m³/sec if intensity of the rainfall is 40 mm/sec and area of drainage is 100 m².

View solution

Q. The side drains and partially filled culverts are designed on the basis of ___________

View solution

Q. The continuity equation is given by __________

View solution

Q. The desirable velocity for sand and silt are __________

View solution

Q. The discharge in m³/sec for a surface drainage of 100 m² and a velocity of 5 m/second is?

View solution

Q. The roughness coefficient is assumed in __________

View solution

Q. The hydraulic radius is given by __________

View solution

Q. What is the maximum value of Manning’s coefficient for soil with heavy vegetation?

View solution

Q. The total time for inlet flow and flow along the drain is given by __________

View solution

Q. If the depth of a trapezoidal section is 0.50 m and free board is 0.15 m, then the total depth is?

View solution

Q. The time of flow in minutes for a longitudinal drain of 400 m and with a velocity of 0.8 m/sec is?

View solution

Q. In slab culverts RCC slab is placed over abudment of __________

View solution

Q. The span of RCC slab is limited to __________

View solution

Q. What is the minimum diameter used in pipe culverts?

View solution

Q. The GWT should be at a distance of _______ from ground level.

View solution

Q. The total interruption to traffic in a year should not exceed __________

View solution

Q. The clay seal may be provided if the seepage zone is at a depth of less than __________

View solution