Q. Which of the following causes the corrosion of terminals and clamps?

View solution

Q. What are the total hours taken by the battery to charge completely?

View solution

Q. Which of the following is defined as the total capacity of the battery to keep the engine running if the charging system fails?

View solution

Q. Which of the following is the abbreviation of CCA?

View solution

Q. How is the rate of charging if there are impurities in the electrolyte?

View solution

Q. How many minutes can a battery of two-minute rate supply before the voltage dropping below 1.5 volts?

View solution

Q. Which are the gasses that get precipitated in the form of bubbles when the battery is overcharged?

View solution

Q. Which of the following has no effect on overheating?

View solution

Q. Which among the following is not a factor affecting the charging of the battery?

View solution

Q. Which of the following helps in the identification of the state of the battery?

View solution

Q. By how much variation in the gravity points cell gravity variation can be found?

View solution

Q. To avoid which of the following the water level in the electrolyte should be checked periodically?

View solution

Q. Which is the liquid that is used in the cleaning of the battery terminals and clamps to avoid corrosion?

View solution

Q. Which of the following is not a cause for deterioration of plates?

View solution

Q. Which of the following is not a reason for the self-discharge of the battery?

View solution

Q. Which of the following increases due to a reduction in the capacity of battery plates due to sulphation?

View solution

Q. Which of the following is the result of long term storage of the battery?

View solution

Q. In which type of battery there is no requirement of any water during normal service?

View solution

Q. Which of the following is the reason for the discolouring of electrolyte?

View solution

Q. Which among the following damage leads to internal short-circuiting?

View solution