Question
a.
5.4 * 10⁻⁶ and 12.6 * 10⁻⁶ per °C
b.
10.8 * 10⁻⁶ and 16.2 * 10⁻⁶ per °C
c.
5.4 * 10⁻⁶ and 10.8 * 10⁻⁶ per °C
d.
10.8 * 10⁻⁶ and 12.6 * 10⁻⁶ per °C
Posted under Concrete Technology
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. For majority of aggregates, the coefficient of thermal expansion lies between approximately ____________
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. For hydrated Portland cement, the coefficient of thermal expansion lies between approximately ____________
View solution
Q. The linear thermal coefficient of expansion lies between approximately ____________
View solution
Q. The specific heat of the aggregates is _____________
View solution
Q. The thermal conductivity of the aggregates is ______________
View solution
Q. The coefficient of thermal expansion affects the heat resistance.
View solution
Q. In crushing test, dry aggregates passing through ________ mm sieve and retained ________ mm in a cylinder.
View solution
Q. According to IS: 2386 part-IV, each layer is tamped ________ times in crushing test.
View solution
Q. A value less than 10 signifies an exceptionally _________ while above 35 would normally be regarded as _________
View solution
Q. Los Angeles machine consists of circular drum of internal diameter ________ mm and length ________ mm.
View solution
Q. Which machine is preferred for abrasion test?
View solution
Q. A maximum value of _________ percent is allowed for WBM base course in Indian conditions.
View solution
Q. Aggregates to be used for wearing course, the impact value shouldn’t exceed ________ percent.
View solution
Q. What is the range of water absorption of aggregates used in road?
View solution
Q. The loss in weight should not exceed ______________ percent when tested with sodium sulphate and ________ percent with magnesium sulphate solution.
View solution
Q. If 60% aggregates doesn’t pass through the 2.36 mm sieve, then what would be the value of Aggregate impact value?
View solution
Q. A maximum value of ___ percent is allowed for WBM base course in Indian conditions.
View solution
Q. Aggregates to be used for wearing course, the impact value shouldn’t exceed __________ percent.
View solution
Q. The loss in weight should not exceed _________ percent when tested with sodium sulphate and _________ percent with magnesium sulphate solution.
View solution
Q. Which type of aggregate is shown below?
View solution
Q. Which type of aggregate is shown below?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Concrete Technology? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
