Q. In charpy test specimen, the angle of v-notch section is ___________

View solution

Q. The indenter used in Brinell hardness test is a ________________

View solution

Q. During compression test of cast iron, the failure occurs i.e. the crack appears along the _________

View solution

Q. In universal testing machine, for a circular section specimen, the gauge length is taken to be _____________
(where A is the area of cross section of the specimen)

View solution

Q. The loss in weight should not exceed ________ % when tested with Na₂SO₄ and ________ % with MgSO₄ solution.

View solution

Q. The mineral oil if present in mixing for concrete ______________

View solution

Q. When sand is fully dry then it’s volume is _________

View solution

Q. Loss on Ignition (L.O.I.) is the loss in weight of cement after being heated to ____________

View solution

Q. IS 1199:1959 is for ____________

View solution

Q. IS 650:1991 is for ____________

View solution

Q. IS 1727:1967 is for __________________

View solution

Q. IS 1489(Part 2):1991 is for ____________

View solution

Q. IS 1489(Part 1):1991 is for ____________

View solution

Q. IS 457:1957 is for ____________

View solution

Q. IS Code of practice for plain and reinforced concrete is ________

View solution

Q. IS code for Specification for Portland slag cement?

View solution

Q. IS code for Specification for coarse and fine aggregates from natural sources for concrete?

View solution

Q. IS code for Specification for ordinary Portland cement, 33 grade?

View solution

Q. According to IRC:15-2011, maximum free W/C ratio for PPC is _________

View solution

Q. According to IRC:15-2011, maximum free W/C ratio for OPC is ________________

View solution