Q. Concrete is not recommended to be placed at a temperature above _________ºC.

View solution

Q. IS: 7861 part-1 deals with ___________

View solution

Q. A higher temperature of fresh concrete results in a __________ hydration of cement.

View solution

Q. Does this reduce handling time?

View solution

Q. Rapid evaporation may cause plastic shrinkage __________

View solution

Q. It is difficult to retain moisture for hydration for rapid evaporation of water during curing period.

View solution

Q. Prepacked concrete _________ water proofing concrete.

View solution

Q. Cement has ________ % volumetric shrinkage after curing.

View solution

Q. After vacuum mixing, the volumetric shrinkage can be raised from 3–5% to __________ % in different cements.

View solution

Q. Vacuum mixing systems reduce the exposure by _________ %.

View solution

Q. The exposure of conventional mixing in open bowl is about ___________ ppm in the breathing zone.

View solution

Q. The __________ compressive strength required from structural consideration.

View solution

Q. The adequate workability necessary for ___________ compaction with the compacting equipment available.

View solution

Q. ___________ water-cement ratio content to give adequate durability for the particular site conditions.

View solution

Q. _______ cement content to avoid shrinkage cracking due to temperature cycle in mass concrete.

View solution

Q. ________ has designated the concrete mixes into a number of grades as M10, M15.

View solution

Q. Maximum nominal size of aggregates to be used in concrete may be as large as possible within the limits prescribed by _______

View solution

Q. Identify the type of destructive testing.

View solution

Q. Which test can be performed without skilled labor?

View solution

Q. Compressive strength of hardened concrete is done by _______

View solution