Q. In the below-shown cross-section of the cylinder diagram, what is the portion name?

View solution

Q. Which of the following is also known as harmonic balancer?

View solution

Q. What is the percentage of carbon present in a cast steel type crankshaft?

View solution

Q. How much is the ultimate tensile strength of the crankshaft material in MPa?

View solution

Q. How many types of crankshaft construction are used universally?

View solution

Q. Which of the following is not a major part of the crankshaft?

View solution

Q. Which of the following material is the most commonly used in the construction of crankshaft?

View solution

Q. Which of the following acts as a damper in a belt-driven crankshaft?

View solution

Q. Which of the following is termed as the escape of the gasses from the combustion chamber and entering into the crankshaft?

View solution

Q. How much percentage of the cylinder bore size concerning the thickness of the crank web?

View solution

Q. Which of the following helps in the uniform speed of crankshaft despite uneven power impulses of the engine cylinder?

View solution

Q. Which of the following is defined as the distance between the axis of the main journal and the crankpin center lines is exactly one half of the engine stroke?

View solution

Q. To withstand which of the following the crank webs are made adequately strong?

View solution

Q. In splash lubrication, the spout is attached to with part of the connecting rod?

View solution

Q. What is the percentage of carbon present in a medium carbon steel type connecting rod?

View solution

Q. Which of the following shows the correct relationship between critical buckling and force acting on the connecting rod?

View solution

Q. Which of the following formula is used to find the force acting on the connecting rod neglecting the cos theta angle and position of the connecting rod?

View solution

Q. Which of the following is defined as whipping stress?

View solution

Q. Which of the following material is used in the manufacturing of the connecting rod?

View solution

Q. For which to which part is the hole drilled for lubrication in a connecting rod?

View solution