Q. Which of the following expressions give the SNR at the output of ADC?

View solution

Q. In non-monotonic filters, attenuation increases with frequency.

View solution

Q. Which of the following is untrue about Sigma-Delta ADC?

View solution

Q. Quadrature sampling uses ____ to ____ the bandwidth available for a particular sampling rate.

View solution

Q. ____, ____ and ____ must be properly matched for effective representation of input signal in quadrature sampling.

View solution

Q. Which of the following is not a characteristic of IC implementation of quadrature sampling ADC?

View solution

Q. In Nyquist sampling, the ____ frequency is ______to the duration of the observation interval.

View solution

Q. Which of the following is not a characteristic of DAC?

View solution

Q. The principle behind Sigma-Delta ADC is oversampling.

View solution

Q. Which of the following is not a part of traditional RF subsystems?

View solution

Q. Limited dynamic range in digital RF system can be improved by _____

View solution

Q. ____ and ____ are the parameters that define software defined radio applications.

View solution

Q. Which of the following influences the spurious free dynamic range?

View solution

Q. The point of intersection of the fundamental signal with the power of third-order intermodulation product is called as _____

View solution

Q. Signal to noise ratio is the preferred metric when ____

View solution

Q. Which of the following is the preferred metric when the desired signal bandwidth is less than Nyquist bandwidth?

View solution

Q. The ratio of ______ the notch filter to the ____ the notch filter gives the Noise Power Ratio.

View solution

Q. If Wₐ is the receiver bandwidth and NF is the noise figure, the noise power of a noise limited receiver is given by the expression ____

View solution

Q. Which of the following applications takes only SFDR as its performance metric?

View solution

Q. Which of the following metrics is considered for spread spectrum method?

View solution