Q. Digital-access bandwidth is approximately double of the sampling rate of the ADC in the isochronous subscriber signal-processing path.

View solution

Q. The introduction of plug and play modules in software defined radio involves partitioning of functions and components

View solution

Q. Which among the following is not a part of RF front-end section in receive mode?

View solution

Q. The circuits of transmit mode in RF front end _____ RF signal.

View solution

Q. ____ time aligns a signal and fits it into the information bandwidth.

View solution

Q. The number of times an electronic signal changes its state is measured by ____

View solution

Q. The modem may include ____ to correct channel multipath artifacts.

View solution

Q. ____ can be used to correct encoded symbols received in error.

View solution

Q. The modem groups the bits to be transmitted into ____

View solution

Q. A ____ is used to represent a symbol.

View solution

Q. ____ depends on the amount of redundancy in a data stream.

View solution

Q. The modem must control ____ to produce the desired carrier frequency.

View solution

Q. Speech application typically runs on ____ processor.

View solution

Q. Which of the following is not a characteristic of cryptographic security?

View solution

Q. ____ is used to identify the creator of information.

View solution

Q. Encryption is a generalized process.

View solution

Q. The modem controls the antenna matching unit to maximize voltage standing wave ratio.

View solution

Q. ____ is used to optimize voltage standing wave ratio.

View solution

Q. In ____ antenna, the interface boundary between radio and antenna is blurred.

View solution

Q. Full duplex means _____

View solution