Q. Bulk modulus of a fluid __________ as the pressure increases.

View solution

Q. The hydraulic gradient line may be above or below the centre line of the pipe.

View solution

Q. A water tank contains 1.3 m deep water. The pressure exerted by the water per metre length of the tank is

View solution

Q. The specific gravity has no units.

View solution

Q. The depth of water in a channel corresponding to the minimum specific energy is known as critical depth.

View solution

Q. The ratio of the inertia force to the gravity force is called Froude number.

View solution

Q. Which of the following statement is wrong?

View solution

Q. A glass tube of smaller diameter is used while performing an experiment for the capillary rise of water because

View solution

Q. The viscosity of a liquid is due to cohesion of its particles.

View solution

Q. A compound pipe is required to be replaced by a new pipe. The two pipes are said to be equivalent, if

View solution

Q. In a footstep bearing, if the speed of the shaft is doubled, then the torque required to overcome the viscous resistance will be

View solution

Q. The viscosity of water is __________ than that of mercury.

View solution

Q. An open tank containing liquid is made to move from rest with a uniform acceleration. The angle 0 which the free surface of liquid makes with the horizontal is such that (where a = Horizontal acceleration of the tank, and g = Acceleration due to gravity)

View solution

Q. The discharge over a triangular notch is

View solution

Q. The discharge through an external mouthpiece is given by (where a = Cross-sectional area of the mouthpiece, and H = Height of liquid above the mouthpiece)

View solution

Q. The loss of pressure head in case of laminar flow is proportional to

View solution

Q. The flow of water through the hole in the bottom of a wash basin is an example of

View solution

Q. The Francis formula for the discharge over Cippoletti weir is

View solution

Q. Laminar flow __________ place at very low velocities.

View solution

Q. A manometer can be used to measure vacuum pressures.

View solution