Q. The pressure of a liquid measured with the help of a piezometer tube is

View solution

Q. The hydraulic gradient line lies over the centre line of the pipe by an amount equal to the

View solution

Q. The flow in a pipe or channel is said to be non-uniform when

View solution

Q. The ratio of the inertia force to the viscous force is called

View solution

Q. A flow whose streamline is represented by a straight line, is called __________ dimensional flow.

View solution

Q. The absolute pressure is equal to

View solution

Q. When the pressure intensity at a point is more than the local atmospheric pressure, then the difference of these two pressures is called

View solution

Q. The hammer blow in pipes occurs when

View solution

Q. When a body is placed over a liquid, it will sink down if

View solution

Q. When a cylindrical vessel of radius (r) containing liquid is revolved about its vertical axis ω rad/s, then depth of parabola which the liquid assumes is

View solution

Q. A manometer is used to measure

View solution

Q. The product of mass and accelaration of flowing liquid is called

View solution

Q. The discharge through a wholly drowned orifice is given by (where H1 = Height of water (on the upstream side) above the top of the orifice, H2 = Height of water (on the downstream side) above the bottom of the orifice, and H = Difference between two water levels on either side of the orifice)

View solution

Q. If the value of coefficient of discharge increases, the discharge through the orifice decreases.

View solution

Q. A point, in a compressible flow where the velocity of fluid is zero, is called

View solution

Q. A differential manometer is used to measure

View solution

Q. The metacentric height of a ship is 0.6 m and the radius of gyration is 4 m. The time of rolling of a ship is

View solution

Q. The point at which the resultant pressure on an immersed surface acts, is known as

View solution

Q. A tank of uniform cross-sectional area (A) containing liquid upto height (H1) has an orifice of cross-sectional area (a) at its bottom. The time required to bring the liquid level from H1 to H2 will be

View solution

Q. The torque required to overcome viscous resistance of a collar bearing is (where R1 and R2 = External and internal radius of collar)

View solution