Question
a.
The pressure on the wall at the liquid level is minimum.
b.
The pressure on the bottom of the wall is maximum.
c.
The pressure on the wall at the liquid level is zero, and on the bottom of the wall is maximum
d.
The pressure on the bottom of the wall is zero.
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A vertical wall is subjected to a pressure due to one kind of liquid, on one of its sides. Which of the following statement is correct?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Water is a __________ fluid.
View solution
Q. The property of a liquid which controls its rate of flow is called viscosity.
View solution
Q. The kinematic viscosity of an oil (in stokes) whose specific gravity is 0.95 and viscosity 0.011 poise, is
View solution
Q. The factional resistance of a pipe varies approximately with __________ of the liquid.
View solution
Q. If the coefficient of discharge is 0.6, then the discharge over a right angled notch is
View solution
Q. According to Bazin, the coefficient of discharge varies with the height of water over the sill of a weir.
View solution
Q. Falling drops of water become spheres due to the property of
View solution
Q. The D-Alembert's principle is used for changing the dynamic equilibrium of a fluid mass, into a static equilibrium.
View solution
Q. Whenever a plate is held immersed at some angle with the direction of flow of the liquid, it is subjected to some pressure. The component of this pressure, in the direction of flow of the liquid, is known as
View solution
Q. The height of a water column equivalent to a pressure of 0.15 MPa is
View solution
Q. The total energy of a liquid particle in motion is equal to
View solution
Q. A notch is used to measure __________ of liquids.
View solution
Q. A flow is called sonic, if the Mach number is unity.
View solution
Q. An error of 1% in measuring head over the crest of the notch (H) will produce an error of __________ in discharge over a triangular notch,
View solution
Q. A flow through a long pipe at decreasing rate is called __________ uniform flow.
View solution
Q. The surface tension of mercury at normal temperature is __________ that of water.
View solution
Q. The celerity (velocity) of a pressure wave in a fluid is given by (where K = Bulk modulus, and ρ = Density of the fluid)
View solution
Q. The pressure intensity in kN/m² (or kPa) at any point in a liquid is (where w = Specific weight of liquid, and h = Depth of liquid from the surface)
View solution
Q. The hydraulic gradient line is always parallel to the centre line of the pipe.
View solution
Q. Barometer is used to measure
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
