Question
a.
Pascal's law
b.
Archimede's principle
c.
D-Alembert's principle
d.
none of these
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A moving fluid mass may be brought to a static equilibrium position, by aplying an imaginary inertia force of the same magnitude as that of the accelerating force but in the...
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The pressure at a stagnation point is always low.
View solution
Q. When an internal mouthpiece is running full, the discharge through the mouthpiece is twice the discharge when it is running free.
View solution
Q. In two dimensional flow, the flow does not take place in a curve.
View solution
Q. In order to avoid tendency of separation at throat in a venturimeter, the ratio of the diameter at throat to the diameter of pipe should be
View solution
Q. The ratio of the inertia force to the __________ is called Euler's number.
View solution
Q. When the flow in an open channel is gradually varied, the flow is said to be
View solution
Q. When the Mach number is equal to unity, the flow is called sonic flow.
View solution
Q. The total pressure on the bottom of a closed cylindrical vessel completely filled up with a liquid is the sum of the total centrifugal pressure and the weight of the liquid in the vessel.
View solution
Q. A weir, generally, used as a spillway of a dam is
View solution
Q. A thick liquid like a syrup has a __________ viscosity than a light liquid like water.
View solution
Q. The highest efficiency is obtained with a channel of __________ section.
View solution
Q. A vessel of 4 m³ contains an oil which weighs 30 kN. The specific weight of the oil is
View solution
Q. Coefficient of discharge Cd is equal to (where Cc = Coefficient of contraction, Cv = Coefficient of velocity, and Cr = Coefficient of resistance)
View solution
Q. In an internal mouthpiece, if the jet after contraction does not touch the sides of the mouthpiece, then the mouthpiece is said to be
View solution
Q. The value of coefficient of velocity for a sharp edged orifice __________ with the head of water.
View solution
Q. The shear stress between the two liquid layers is __________ proportional to the distance between two layers.
View solution
Q. The mass per unit volume of a liquid at a standard temperature and pressure is called
View solution
Q. The centre of pressure acts __________ the centre of gravity of immersed surface.
View solution
Q. A flow through an expanding tube at constant rate is called
View solution
Q. When a body is placed over a liquid, it is subjected to gravitational force and upthrust of the liquid.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
