Q. Reheating in a gas turbine

View solution

Q. In a single stage, single acting reciprocating air compressor, without clearance, the workdone on the air during isentropic compression is __________ the heat required to raise the temperature of air from T1 to T2 at a constant pressure.

View solution

Q. Workdone by an air compressor __________ upon the way in which the air is compressed.

View solution

Q. In a compressor, work is done on the piston during suction of air and work is done by the piston during compression as well as delivery of air.

View solution

Q. In a compressed air system, the temperature of air discharged from the air motor is __________ than the initial compressor intake temperature.

View solution

Q. The efficiency of roots blower __________ with the increase in pressure ratio.

View solution

Q. The operation of lifts, rams and pumps make use of compressed air.

View solution

Q. A jet engine has

View solution

Q. A receiver in compressor installations is used to damp pressure waves in compressor discharge.

View solution

Q. The axial flow compressor is preferred in air-craft gas turbines because of

View solution

Q. Which of the following statement is correct as regard to centrifugal compressors?

View solution

Q. The ratio of the net work obtained from the gas turbine plant to the turbine work is known as

View solution

Q. The process, which causes the air to enter the impeller blades of a centrifugal compressor at __________ velocity (without effecting the mass of air to flow and velocity of flow) is known as prewhirl.

View solution

Q. In jet propulsion power unit, the inlet duct of diverging shape is used for converting kinetic energy of air into pressure energy.

View solution

Q. Maximum work is saved in a two stage reciprocating air compressor with incomplete intercooling.

View solution

Q. The mass of gas turbine per kW developed is about __________ as that of an I.C. engine.

View solution

Q. In a centrifugal compressor, the ratio of the __________ to the blade velocity is called slip factor.

View solution

Q. In a turbo jet engine, subsequent to heat addition to compressed air, to get the power output, the working substance is expanded in

View solution

Q. The air is delivered __________ in one revolution in case of a three-lobbed rotor.

View solution

Q. The temperature of air at the beginning of the compression stroke is __________ the atmospheric temperature.

View solution